Realising the importance of branding products, Ansun has the best facility in the country to customise all it's products like Zipper Sliders, Buttons, Badges, Dog Hooks , Buckles , Fittings, Pant Hooks etc. This will help you to facilitate the Brand endorsement on your products in a very effective and stylish manner. We also design the complete products just to suit any of your personalised needs.


Customisation Process at Ansun

Step1 - In this initial stage all we require is an artwork or even a sample from the client. You can send us the Image by Email as a jpeg or any other graphic file or else by Fax or mail.

Step 2 - The Image is then converted into a 2D or a 3D CAD Drawing or a Model and sent for approval to the Customer either by Email or Fax. This process normally takes around 3 working days after the initiation process.

Step 3 - Changes if any are incorporated as per the feed back from the customer and the design and manufacturing for the required Moulds and Tooling is taken up. Up to this stage normally the time required is 5~6 days.

Step 4 - After the tooling is ready, test run is done and the samples are subjected to a very critical Engineering Inspection for dimensional accuracy and Visual perfection. After the samples are cleared by our Inspection team, the same after completing the Assembly & Finishing are Inspected once again by the Quality Controller after his clearance are sent to the customer for final approval.

Step 5 - After getting final customer approval in all aspects, the production starts and the products are shipped to the client. It normally takes fifteen to twenty days to deliver the final product. All along the customer is kept fully informed of all developments and the status at our end mostly by Email or sometimes by Phone.

Apart from our efforts to make quality product and timely delivery, we expect certain efforts like providing exact briefing, and appropriate comments for the sample from the customer also as this helps in successful timely completion of the development cycle.

Quantity and Costing
Development of Customised Sliders, Buttons and other fittings is a bit expensive due to the cost of dedicated Tooling which needs to be developed specially. But this cost is an Investment for your end product, because this customisation only will make your end product stand out from the crowd and bring you many times more Brand Equity and higher profit.

Though the minimum quantity of a regular product may vary, for the development of a new product, the product has to be the minimum reasonable quantity to cover up the product development cost including designing, dedicated tooling etc.

The minimum quantity of order may come down for additional cost.